Mac OS 9 Discussion > Hardware
strange issue
supernova777:
ok so im adding a sata drive to my quicksilver g4
and the machine refuses to bong + start up as long as i have the sata power adapter connected.. if i unplug the sata power.. it starts up fine! seriously at my wits end.. i dont get it why is this happening?
im wondering if its some type of ground vs hot wire mismatch? but these things are all standardized... i dont understand
supernova777:
ok well.. i somehow managed to fry the 500gb drive.. so thats why its not starting on.. the drive is FRIED
wow i just lost a 500gb drive.. well there goes another 50$ wasted somehow *sigh*
;)
MacTron:
--- Quote from: chrisNova777 on January 19, 2014, 09:20:03 AM ---ok so im adding a sata drive to my quicksilver g4
and the machine refuses to bong + start up as long as i have the sata power adapter connected.. if i unplug the sata power.. it starts up fine! seriously at my wits end.. i dont get it why is this happening?
im wondering if its some type of ground vs hot wire mismatch? but these things are all standardized... i dont understand
--- End quote ---
What kind of SATA adapter are you using?
I've had little inconvenients with some. Take care of the Master/Slave thing...
supernova777:
its just a normal molex 4 pin -> sata power adapter
if i have the adapter attached to the hard drive the computer wont start
i just tried the same hard drive-- in an external dock.. and the dock wont turn on .. but turns on fine with another drive in it..
so i dunno what i did to this drive.. but its fried.. and it wont let anything else turn on that its connectd to. i dont even understand how thats possible..
but thats whats happening
the drive was working 100% earlier too..
:/
supernova777:
i think i shorted the drive by putting the +5v red wire to one of the black ground wires on the power adapter..
not sure if therse anything i can do about it now
i guess its dead and i did smell a burnt smell a bit...
Navigation
[0] Message Index
[#] Next page
Go to full version