91
Hardware / Re: AcBel PSU / Quicksilver
« Last post by indibil on April 18, 2024, 10:52:48 PM »Hello.
I have a QS 800MHz that when you press the button, it starts and stops. I have dismantled the power supply and bridged the green cable with the black one, and when I connected it the same thing happened. The source is AcBel 614-0157 QS PSU like the one @Jacques shows.
So I followed the tutorial.
None are swollen. C10 gives a correct value. C13, C16 and C29 of 2000uF give me a value of 3300uF and about 3-4ohm of resistance. When it seems strange, I replaced them.
The power supply was very clean.
After replacing them the problem persists, exactly the same. The fan control daughter board has few capacitors. Today I will try to check and replace some more, but I am afraid that my power supply has another problem.
I have a QS 800MHz that when you press the button, it starts and stops. I have dismantled the power supply and bridged the green cable with the black one, and when I connected it the same thing happened. The source is AcBel 614-0157 QS PSU like the one @Jacques shows.
So I followed the tutorial.
None are swollen. C10 gives a correct value. C13, C16 and C29 of 2000uF give me a value of 3300uF and about 3-4ohm of resistance. When it seems strange, I replaced them.
The power supply was very clean.
After replacing them the problem persists, exactly the same. The fan control daughter board has few capacitors. Today I will try to check and replace some more, but I am afraid that my power supply has another problem.