Sorry I missed out on it Diehard.

Just another question tho...

I read in some Macintosh system requirements for the Delta 44 that G3/G4 accelerator cards not supported,
I have a OWC Mercury Extreme G4 in my Quicksilver - could this be the issue that is preventing me from getting sound out of the breakout box?

Delta 44

Minimum system requirements (MAC) :are G3/G4 (accel. cards not supported) 500MHz, OS 9.2.2, 128MB RAM; OS X 10.1.5, 10.2.6 or greater, 256MB RAM, OMS 2.3.8 for MIDI under OS 9.2.2

just bought the above belkin kvm switch in "unused" condition.

iīve read a few negative reports about it, but until now it does what it should.

have not yet tested cables longer than 3 meters. because of my usual "cable length issues" (monitors in the center, computers all around in the room) it is not ideal to use a switch with built-in connections, i would prefer to use very short cables with it when used with 2 minis.

donīt forget (i almost did) that if you use WUXGA or greater, you can only use the G4 minis with it; the VGA output of the core2duo models canīt handle such a monitor properly, it is required to connect them via DVI-D.

You need to copy this TDM file to the DAE folder and after that Pro Tools will see SC Plus 2. You also need to configure OMS for SampleCell to work. Good luck.

Yes, but how about do opposite and route systems sounds to ASIO device with Spig (I remembered name at last).

to do that, all you need is an ASIO app of your choice.

unless the involved programs offer something better, like direct connect, a dedicated VST plug-in or rewire.

giving the finder (or actually the system?) itself native ASIO support will be more than a hack from my understanding.

downloaded from garden once installed it asks me for an authorization or a 15 day demo use.. I don't understand how you can use it without software..it's not in Protools...