Mac OS 9 Lives
Mac OS 9 Discussion => Hardware => Topic started by: Syn-Fi on November 14, 2017, 01:29:40 AM
-
hi,
i purchased my Quadra 3 months ago and it didn't seemed to have seen much use and there was no signs of a leaking battery so i put off any serious servicing and just the unit and installed a scsi/ide bridge with compact flash. Latterly, it would not boot up consistently so i investigated the caps and noticed there was black ooze into traces....especially the ground. This was confirmed when i started lifting some of the caps off the board, both in terms of black liquid and smell.
The ground on the Quadra 840av is meagre and so i replaced all the caps and also wired main point where the ground on the pcb goes to the power cable. The quadra is working fine now.
Use a heat gun to remove the SMD caps and then an iron, with plenty of flux to solder them on - you need some dexterity with the soldering iron.
one thing i would note is that the PSU seems to be running, mildly warm, even when the unit is switched off. i only noticed this as we get into the Winter months and i checked it with my IR heat gun. I now switch off the unit from a ganged extension mains distribution panel.
So, if anyone is recapping - shore up the ground too