Welcome Board (Our Community, News, Mac OS Installation Help, Marketplace) > Community Marketplace

Wanted: 10-Node Digidesign TDM ribbon cable

(1/8) > >>

Knezzen:
Hi!

Im searching far and wide for a 10-node Digidesign TDM ribbon cable. Used to hook up MIX Core and Farm cards with each other.

Post if you have one laying around or know where I can find one!

Thanks!

Syntho:
I've never understood how a 10-node works. As far as I know only 7 cards can be used at any given time and I think there's a 7-node cable out there. But a 10 node?

Knezzen:

--- Quote from: Syntho on March 19, 2014, 07:45:52 AM ---I've never understood how a 10-node works. As far as I know only 7 cards can be used at any given time and I think there's a 7-node cable out there. But a 10 node?

--- End quote ---

They never did make a 7-node from what I know. You can have more than 7 MIX cards, but digidesign don't support it officially. The last 3 nodes on a 10-node cable can be connected to the older DSP Farm cards (since they don't use alot of bandwidth) or Samplecell TDM cards.

EDIT: Sorry, there was a 7-node cable as well :)

Syntho:
I'm not sure i'll ever go over 4 cards or so. The maximum number of I/O as far as I know is 72, and that'll take eight 888|24s, eight digi cables, and four Y cables for 64 I/O, plus an additional 888|24 and a digi cable to make it 72. That'll run off of 5 Mix cards.

After that, it's just farms/samplecell for more power.

Knezzen:
Cable no longer needed. I built my own from some old PATA cables and the connectors from two 5-node cables.

Navigation

[0] Message Index

[#] Next page