Howdy folks,
I have a blue and white AGP G4 I am trying to install Os9 on. I have both the Os9.1 orange and white DVD from Apple and the Os9.2.2 copy from here burned to CD. I have been using an iBook G3 with Tiger 10.4.11 that dual boots into Os9 using the 9.2.2 copy from here to format a 120GB IDE drive using APM and the Os9 drivers.
If I clone the iBook G3 with Tiger 10.4.11 hard drive onto the 120GB HD, the G4 boots into Tiger fine but continually glitches if I try to boot into the Os9.2.2 'drive' and wont boot Os9. If I try a clean install of Os9 onto the 120GB IDE drive using the Os9.1 orange and white DVD from Apple or the Os9.2.2 copy from here burned to CD it starts the installation but always stalls at the point where the hard drive would mount - apparent a a flashing disk or folder icon with a question mark. During the installation from the Apple Os9.1 DVD it also comes up with an 'unimplemented trap' system error and prompts to reboot while holding down the shift key to temporarily turn off extensions. Open firmware reports DEFAULT CATCH!, code=300.
I have tried resetting the PRAM, NVRAM, have reset the PMU and replaced the battery on the logic board. I have also tried partitioning the 120GB drive all to no avail. I don't think the hard drive is bad, it did require repair after cloning the iBook hard drive but otherwise has behaved.
Any suggestions?, is it something simple like 'blessing' the System folder (i only just read about it). Or it this a hardware issue on an aged G4?
thanks