Author Topic: JL Cooper cs-10 and OMS  (Read 4092 times)

Offline Che1366

  • Newcomer
  • Posts: 3
  • new to the forums
JL Cooper cs-10 and OMS
« on: September 16, 2019, 02:14:09 AM »
I have a jl cooper cs-10. It is connected to the printer port. How to make it appear in OMS studio.
I can't find drivers for it anywhere

Offline GaryN

  • Platinum Member
  • *****
  • Posts: 1566
  • active member
Re: JL Cooper cs-10 and OMS
« Reply #1 on: September 16, 2019, 12:45:07 PM »
It doesn't require a driver. You simply need to open your OMS Studio Setup panel and click "Add new device". Check the "is a controller" box, the channels you will be sending on (you can start will all of them checked) and you're good to go.

Offline Che1366

  • Newcomer
  • Posts: 3
  • new to the forums
Re: JL Cooper cs-10 and OMS
« Reply #2 on: September 17, 2019, 03:24:50 PM »
I did. In OMS it appears, but pro tools 5.1.3 does not see it. The rest of the devices are there, but there is no new one added

Offline GaryN

  • Platinum Member
  • *****
  • Posts: 1566
  • active member
Re: JL Cooper cs-10 and OMS
« Reply #3 on: September 17, 2019, 03:51:03 PM »
Make certain PT is seeing and using the current OMS Studio Setup.