Author Topic: GeForce4 Ti4600 mounting hole distance?  (Read 400 times)

Offline Knezzen

  • Platinum Member
  • *****
  • Posts: 720
  • Pro Tools addict!
    • Macintosh Garden
GeForce4 Ti4600 mounting hole distance?
« on: June 04, 2017, 01:44:28 AM »
Trying to find the mounting hole distance for the Ti4600, does anyone here know?
I know that the plastic clips are 80mm apart, Im thinking of the 4 holes around the GPU itself.


Offline GaryN

  • Platinum Member
  • *****
  • Posts: 625
  • active member
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #1 on: June 04, 2017, 06:16:30 PM »
Just measured my "loose" board - (from the back, since the heat sink is attached). Oddly, as certain as I was that the measurement would be metric, it's not.
The holes are exactly 1-1/2 inches square.
Go figure…

Offline mrhappy

  • Platinum Member
  • *****
  • Posts: 836
  • new to the forums
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #2 on: June 05, 2017, 05:05:20 AM »
I was that the measurement would be metric

Maybe it is... 3.81cm... a nice round number! ;D ;D

Offline GaryN

  • Platinum Member
  • *****
  • Posts: 625
  • active member
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #3 on: June 05, 2017, 04:45:05 PM »
Maybe it is... 3.81cm... a nice round number! ;D ;D
What on Earth would we do without you, Hap?

Offline Knezzen

  • Platinum Member
  • *****
  • Posts: 720
  • Pro Tools addict!
    • Macintosh Garden
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #4 on: June 05, 2017, 09:58:01 PM »
Gary, could you measure it diagonally as well? The distance from say the lower right to the uppe left hole?

Offline GaryN

  • Platinum Member
  • *****
  • Posts: 625
  • active member
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #5 on: June 06, 2017, 02:56:20 PM »
Gary, could you measure it diagonally as well? The distance from say the lower right to the uppe left hole?

2-1/8" exactly

Offline dr bu

  • Silver Member
  • ****
  • Posts: 172
  • Max/Msp 4.1 lives!
Re: GeForce4 Ti4600 mounting hole distance?
« Reply #6 on: June 06, 2017, 03:07:37 PM »
make that cm please  :)
lookin for original M-audio audiophile 2496 drivers (ver 1.x)!!