guys im getting a marathon mix rig to run pro tools on os9
soooo excited but the hdd died
so i need to reinstall from fresh
the atto ul3d - never dealt with scsi - is included. which ssds and adapters do i need to buy for solid state work these days and can someone please post all atto software for it to run since atto -created account- doesnt host them anymore
digidesign:
ATTO ExpressPCI UL3D
Dual Channel Ultra3 SCSI Host Bus Adapter
ATTO ExpressPCI Firmware v1.66 or higher required, available from
www.attotech.com/software - NOT ANYMORE THEY ARE!!
ATTO ExpressPro-Tools v2.7 or higher required, supplied on Pro Tools CD-ROM or from
www.attotech.com/software or Digidesign/Support/Downloads/UtilitieS -- Not anymore they are
Product Information
Model # EPCI-UL3D-000 *
* The 66MHz version of the ATTO EPCI-UL3D (model # EPCI-UL3D-066) is not supported for use with Pro Tools systems, regardless of whether your Pro Tools system is installed on a 33 MHz or 66 MHz PCI bus. The 66 MHz version is tuned for performance on a 66 MHz PCI bus. However, when Pro Tools is installed in a 66 MHz PCI bus, it reduces the speed of the PCI bus to 33 MHz. As a result, you will receive superior performance with the 33 MHz UL3D (model # EPCI-UL3D-000), because it is tuned for a 33 MHz PCI bus.
Recommended ATTO settings for approved SCSI Host Bus Adapters:
From the Sync Rate pop-up menu, select "20 (10)" (20 MB/sec at 10 MHz)
From the PCI Burst Rate pop-up menu, select "32"
i guess a capeable pro tools os9 guy can help me here?
- firmware atto software to get this running on a fresh install
- working ssd and scsi adapter for pt os9
love u guys thanks this rig must rock